OEM Made In China Agricultural spare parts L4508 Pto Shaft

OEM Made In China Agricultural spare parts L4508 Pto ShaftProduct DescriptionCharacteristic How do you replace an L4508 Pto Shaft? There are two methods. First, measure the driveline yoke. Measure the u-joint end-to-end both ways. Using calipers, measure the outside diameters of the u-joint caps. Ne......

Send Inquiry

Product Description

OEM Made In China Agricultural spare parts L4508 Pto Shaft

Product Description

Characteristic

How do you replace an L4508 Pto Shaft? There are two methods. First, measure the driveline yoke. Measure the u-joint end-to-end both ways. Using calipers, measure the outside diameters of the u-joint caps. Next, use a cross and bearing identification chart to match the measurements to the correct model. If you have the correct dimensions, you should be able to remove the u-joint cap and replace the shaft.
1-1/8" six-spline 540 RPM
If you're looking to extend the PTO shaft on your tractor, you'll need to buy a PTO adapter. These parts will increase the length of your tractor's PTO shaft and fit into implements with different PTO shaft sizes. Here are some tips on choosing the right PTO adapter for your tractor. Adapters come in two different sizes to fit any tractor PTO.
Cross and bearing kits
If your L4508 PTO Shaft is not turning freely, it may be time for a replacement. Cross and bearing kits for L4508 PTO Shaft can be purchased from an automotive or agricultural parts dealer. They are interchangeable with standard cross and bearing sets. Cross and bearing kits for L4508 PTO Shaft are made of high-quality steel and feature an 8-hour lube cycle.
Shaft yoke
A proper Shaft Yoke is an integral part of a PTO drive system. This component allows the PTO shaft to attach to a tractor or device. The shaft is protected by a Guard, which is a hard plastic cover. The correct sizing for your tractor's horsepower is based on this closed length. The following information will help you choose the proper shaft yoke.
When replacing the yoke, first make sure you have the right cross and bearing kit. This kit contains snap rings on the yoke ears and the u-joint caps. Then, measure the yoke ears using calipers. Match the measurements against the cross and bearing identification chart. When measuring the yokes, make sure to measure the inside diameter of the u-joints.
Slip clutch
The slip clutch on the L4508 Pto shaft needs to be adjusted if it has slipped. You can adjust the slip clutch by loosening or
tightening the clutch bolts. The length of the bolts should be the same as the clutch plate. The springs should not be cracked. If you are unable to align the clutch, check the alignment with a permanent marker or a stick provided by the manufacturer.You must install the slip clutch on the PTO shaft of the tractor. If you do not, you could damage the tractor's PTO drive and the
PTO shaft. You should install the slip clutch on the equipment side of the PTO shaft. If the shaft is not tightened, it could lead to a dangerous PTO. It is recommended to replace the clutch every few years. The slip clutch is not a difficult part to install.